Sonicwall

This article will help you establish a site-to-site IPsec connection between Timus Networks and Sonicwall.

IPsec tunnel between Timus - Sonicwall: Sonicwall Configuration for Timus:

Go to Object -> Match object -> Addresses -> add to create address object for Local network.

Go to Object -> Match object -> Addresses -> add to create address object for Timus Network.

Go to Network -> IPsec VPN -> Rules and Settings -> Add

General:

Network:

Proposals:

Advanced:

Dead Peer Detection should be Disabled and NAT Traversal should be Enabled on Sonicwall:

Timus Configuration for Sonicwall:

• Go to the Timus Manager -> Sites -> Create New Please note that you need to have a gateway to be able to create an IPsec tunnel(Connector)

• After clicking on Create New, you need to select Connector on top and enter an IPsec tunnel name, which is required.

Parameters:

• Note- you now have the option to select "Create firewalls rules automatically"

Miscellaneous:

• To enable Dead Peer Detection(DPD) is highly recommended. Therefore, once the IPsec tunnel gets down for some reasons, it will automatically connect back and it will be Established/Online again.
• After configuring the Phase 1 IKE configuration of Timus, you need to hit Save.
• After saving, please extend the gateway by clicking on the arrow, and click on the 3 dots at the end of the row. After that, click on View.

• After clicking on View, you will be the page where you can add/edit the Phase 2 configuration, click on Create New Tunnel to create a Phase 2 configuration for your IPsec.

Phase 2 configuration of Timus:

• Note- you now have the option to select "Create firewalls rules automatically"

• After configuring the Phase 2, click on Save.