Sonicwall

This article will help you establish a site-to-site IPsec connection between Timus Networks and Sonicwall.

IPsec tunnel between Timus - Sonicwall: Sonicwall Configuration for Timus:

Go to Object -> Match object -> Addresses -> add to create address object for Local network.

Go to Object -> Match object -> Addresses -> add to create address object for Timus Network.

Go to Network -> IPsec VPN -> Rules and Settings -> Add

 

General:

Network:

 

Proposals:

 

Advanced:

 

Please ensure All Configurations below are matched. Otherwise:

  • IPsec Connection issues.

  • Issues with packet transfer and connectivity between peers on opposite ends of the tunnel.

 

Untitled.png

Timus Configuration for Sonicwall:

  • Go to the Timus Manager -> Sites -> Create New Please note that you need to have a gateway to be able to create an IPsec tunnel(Connector)

  • After clicking on Create New, you need to select Connector on top and enter an IPsec tunnel name, which is required.

Parameters:

  • Note- you now have the option to select "Create firewalls rules automatically"

Miscellaneous:

  • To enable Dead Peer Detection(DPD) is highly recommended. Therefore, once the IPsec tunnel gets down for some reasons, it will automatically connect back and it will be Established/Online again.
  • After configuring the Phase 1 IKE configuration of Timus, you need to hit Save.
  • After saving, please extend the gateway by clicking on the arrow, and click on the 3 dots at the end of the row. After that, click on View.

  • After clicking on View, you will be the page where you can add/edit the Phase 2 configuration, click on Create New Tunnel to create a Phase 2 configuration for your IPsec.

Phase 2 configuration of Timus:

  • Note- you now have the option to select "Create firewalls rules automatically"

  • After configuring the Phase 2, click on Save.

Updated

Was this article helpful?

2 out of 2 found this helpful

Have more questions? Submit a request

Comments

1 comment

  • Comment author
    NASA Souris

    Great documentation.  You don't often see vendors put instructions for both sides.

    I hope it gets updated when SonicWall updates their GUI.

    0

Please sign in to leave a comment.